• October 21, 2021
    Upcoming Events
    No Events Found
    << October 2021 >>
    S M T W T F S
    1 2
    3 4 5 6 7 8 9
    10 11 12 13 14 15 16
    17 18 19 20 21 22 23
    24 25 26 27 28 29 30
    31
  • Cement Mason Tools Required At Start Of Apprenticeship
    Dec 28, 2015
    NORTHERN CALIFORNIA CEMENT MASONS
    JOINT APPRENTICESHIP AND TRAINING COMMITTEE
    www.NorCalCementMasonsApprenticeship.org
    Cement Mason Apprentices will be required to furnish the following
    "BAG OF TOOLS":
    (3) Three trowel (14x4, 18x5, 20x5), varying in size to fit work)
    (1) One pointer (margin trowel)
    (1) One set of coving tools (1 nose & 1 cove)
    (1) One fiberglass hand float (16 x 3 1/2 resin or aluminum)
    (1) One rubber float (orange 12 x 4)
    (1) One hammer (18 oz)
    (1) One sledge hammer ( 4 lbs or more)
    (1) One hand saw (combination)
    (1) Three hand edgers (1/4", 1/2", & 3/4" radius to match coving tools) 6X6
    (1) One set of knee pads
    (1) One set of knee boards
    (1) One hand brush (paint brush)
    (2) Two levels (1 pocket & 1-24" or longer - 48" preferred)
    (1) One pair pliers w/side cutter
    (1) One measuring tape (25')
    (1) One roll nylon cord (300')
    (1) One carpenter pencil
    (1) One marking crayon
    (1) One nail/tool apron
    (1) Rubber buckle boots 2 size larger than work boot
    Note: These are the minimum tools required as defined in the Master Labor
    Agreement and must be obtained immediately upon entering the Northern
    California Cement Masons Apprenticeship Program.


    Download:
    Cement_Tools-List_v2.pdf
  • OPCMIA 300

    Copyright © 2021.
    All Rights Reserved.

    Powered By UnionActive


  • Top of Page image